Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Front Passenger Side Seat Belt Warning Light does not Operate

Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Seat Belt / Seat Belt Warning System / Front Passenger Side Seat Belt Warning Light does not Operate

DESCRIPTION

The combination meter assembly blinks or turns off the passenger seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly (for passenger side) and occupant detection sensor (front seat cushion pad (for passenger side)).

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

The seat belt warning system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

Click here

HINT:

The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat. Check that the operation of the seat belt warning light is normal first.

Click here

If the seat belt warning light does not operate for both the driver seat and front passenger seat, replace the combination meter.

Click here

PROCEDURE

1.

CHECK DTC OUTPUT (AIRBAG SYSTEM)

(a) Clear the DTCs.

Body Electrical > SRS Airbag > Clear DTCs

(b) Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes

Result

Proceed to

DTCs are not output

A

DTCs are output

B
B

GO TO AIRBAG SYSTEM

A

2.

READ VALUE USING GTS

(a) Read the Data List according to the display on the GTS.

Body Electrical > SRS Airbag > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Passenger Seat Buckle Switch Status

Passenger side seat belt buckle switch status

Unknown, Unbuckle, Buckle, or Malfunction

Unknown: Data is not determined

Unbuckle: Passenger side seat belt not fastened

Buckle: Passenger side seat belt fastened

Malfunction: Failure is detected

-
Body Electrical > SRS Airbag > Data List

Tester Display

Passenger Seat Buckle Switch Status

Result

Proceed to

Unbuckle or Buckle is displayed on the GTS according to the driver seat belt condition

A

Unbuckle or Buckle is not displayed correctly on the GTS according to the driver seat belt condition

B

NG is displayed on the GTS

C
A

USE SIMULATION METHOD TO CHECK

B

REPLACE FRONT SEAT INNER BELT ASSEMBLY RH

C

REPLACE AIRBAG ECU ASSEMBLY

    READ NEXT:

     Rear Seat Belt Warning Light Malfunction

    DESCRIPTION The power distribution box assembly sends a signal indicating a rear seat belt status when the ignition switch is ON to the main body ECU (multiplex network body ECU) via CXPI communicatio

     Tongue Plate Stopper

    ComponentsCOMPONENTS ILLUSTRATION *1 TONGUE PLATE STOPPER - - ● Non-reusable part - - ReplacementREPLACEMENT PROCEDURE 1. REMOVE TONGUE PLATE STOPPER

     Seat Belt

    SEE MORE:

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL Click here 2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Click here 3. REMOVE FRONT DISC Click he

     Acoustic Vehicle Alerting Speaker Circuit Open (B135013,B135019)

    DESCRIPTION The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly. This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit or vehicle approaching speaker controll

    © 2020-2025 Copyright www.tcorollacross.com PT NL