Toyota Corolla Cross: Check Mode Procedure
CHECK MODE PROCEDURE
CHECK MODE: DTC CHECK
(a) Select "Check Mode" and proceed with checking using the GTS.
Body Electrical > SRS Airbag > Utility
|
Tester Display |
| Check Mode |
NOTICE:
Select Check Mode on the GTS to clear the DTCs (both current and history).
HINT:
- DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
- Perform check mode inspection when DTCs were not output through normal diagnosis mode inspection regardless of whether a malfunction in a squib circuit is suspected.
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST CAUTION:
Never measure the resistance of the SRS parts because current from the tester may cause the SRS parts to deploy.
NOTICE: In the table below, the values
HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR PROCEDURE
1. TYPES OF AIRBAG CONNECTOR (a) Types of Connector
TYPE Shape (Example)
Pull Up Type
2-Step Lock Type
DIAGNOSTIC TROUBLE CODE CHART Airbag System
DTC No. Detection Item
Warning Indicate Test Mode / Check Mode
Link B000111
Driver Frontal Stage 1 Deployment Control Circuit
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 LEAK DETECTION PUMP SUB-ASSEMBLY
77740R
- -
2 CANISTER (CHARCOAL CANISTER ASSEMBLY)
77740 -
- -
3 CHARCOAL CANIS
DESCRIPTION The crankshaft position sensor sends an engine speed signal (NE signal) to the ECM. The engine speed signal is then sent directly from the NEO terminal of the ECM to the engine stop and start ECU. Additionally, the ECM sends the engine speed to the engine stop and start ECU via CAN commu
