Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Brake System (for Gasoline Model)

Toyota Corolla Cross (2022-2026) Service Manual / Brake / Brake System (other) / Brake System (for Gasoline Model)

Precaution

PRECAUTION

NOTICE:

  • This vehicle is equipped with an SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System.

    Click here

  • Care must be taken to replace each part properly as it could affect the performance of the brake system and result in a driving hazard. Replace the parts with those having the same part number or equivalent.
  • It is very important to keep parts and the area clean when repairing the brake system.
  • If the vehicle is equipped with a mobile communication system, refer to the precautions in the Introduction section.

    Click here

    READ NEXT:

     Brake System (for Hev Model)

    Precaution PRECAUTION CAUTION: While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or the door c

     Vacuum Pump

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. OPERATION CHECK (a) Slide the clip and disconnect the check valve to connector tube hose from the vacuum pump assembly. (b) Connect the hose of the

    SEE MORE:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame. (a) Check that the float moves smoothly between F and E. (b) Check the fuel sender gauge assembly voltage. (1) Apply 5 V b

     Inspection

    INSPECTION PROCEDURE 1. INSPECT CYLINDER BLOCK FOR WARPAGE (a) Using a precision straightedge and feeler gauge, check the surface which contacts the cylinder head gasket for warpage. Maximum Warpage: 0.05 mm (0.00197 in.) HINT: If the warpage is more than the maximum, replace the cylinder

    © 2020-2026 Copyright www.tcorollacross.com PT NL